![u boot console u boot console](https://cdn.cloudflare.steamstatic.com/steam/apps/1078800/ss_7cf328d3482043e0ab2b857c22e8b060b294adcf.1920x1080.jpg)
Note that the update operation will overwrite the flash memory storing the environment configuration, so if you wish to preserve it you need to save it again:Īt this point the U-Boot binary is stored in flash. You will see output similar to the following: Next, run the U-Boot update command to copy the U-Boot loader file from the host PC to the target board, and write it into flash: Next, set the serverip variable to the IP address of your host PC where the TFTP server is running: Where is the IP address you want to assign. If you want to manually assign an IP address: The console should report the IP address allocated to the board. This can either be a static address or DHCP allocated. In the U-Boot console, configure the board IP address. SF: Detected IS25LP512 with page size 256 Bytes, erase size 64 KiB, total 64 MiB Press a key to interrupt the boot process before the countdown terminates: You should see U-Boot booting in the minicom console. Where the macros in the above command are listed at the bottom of this page in Appendix.Īt this point U-Boot will now be running in RAM on your target board. $ /opt/analog/cces/2.8.3/ARM/arm-none-eabi/bin/arm-none-eabi-gdb
![u boot console u boot console](https://images.modhoster.de/system/files/wip_project/0077/2193/huge/u2540-u-boot-typ-xxi.jpg)
Info : adspsc58x.dap: but you can only set 1 watchpoint Terminal3: Loading U-Boot With GDB In a third console window launch GDB and load the U-Boot image to flash: Info : adspsc58x.dap: hardware has 3 breakpoints, 2 watchpoints Info : ICE-1000 firmware version is 1.0.2 Info : transports supported by the debug adapter: "jtag", "swd" Open On-Chip Debugger (Analog Devices CCES 2.9.0 OpenOCD 0.9.0-ga44a178) 0.9.0 When success you should see a message similar to the console output below: